I am sorry for the late replay, I really cant tell if there is a complete version of the protection card. WHERE CAN I FIND PCB FOR PROTECTION CARD FOR THAT SMPS?AND.CAN I USE ER元5-C INSTEAD ETD-59? MY Requirements.FOR SUPPLYING SOLID STATE MOSFET AMPLIFIER. ONLY I WANT TO BE STABLE WITH PROTECTION.SO, I SO SOME FILES FROM LUDO WITH IR2153 AND I WANT TO ASK. I'M NEW ON THIS FORUM AND I LIKE TO MAKE SMPS. And yes, the proper way is shut down IR2110 at the same time.ĪND REGARDS TO Mr. The SMPS at the front page is the OLD version of the commercial design I made long time ago. I am sure that you are talking about the regulated SMPS, and this is not Regulated SMPS. Which smps project is that the lay out looks attractive. About the smps photo given at the front page of the site.
Shutdown will be fast if applied to IR2110. The duty cycle of 3525 is reduced by the DT resistor 100R, can the DT be reduced so that feed back voltage control can be given. If it is 2.5V or above LM393 can be replaced wit cheaper TL431. Unfortunately, I can't load it from work anymore but, assuming its the right file. What will be the output voltage of the CT at which the tripping is set.ĭiysmps > diysmps! > diysmps > SG3525 IR2110 50Khz 900W SMPS Question. I have some doubts to clear in your smps project. Hi, I am new to the forum my congratulations for the nice work going on, especially to Microsim,Ludo,Luchini, khron,kaip,michelle,stewin and others.
0 kommentar(er)
